Should I strip my car paint to metal…and what are some methods that works well? There are times that it is neccisary to strip the paint on a car down to metal. But as I will explain in this video, it may actually be better not to. That is my opinions! It’s kinda like asking […]
Can Glaze Putty Be Applied Over Primer Surfacer?
I was asked if glaze could be applied over primer surfacer. For instance, if you already primed and blocked the surface and find a low you didn’t know about, then what do you do… I am going to answer that question in this quick Q&A video below. If you have questions, the best way to […]
How Far To Strip Off The Paint On My Car To Repaint
I got this question on my YouTube channel. It’s actually a very good question and misunderstood many times. If you have a restoration job and there is layers of paint and perhaps rust, then a full strip down to the metal is going to be required. However, if the paint is original and in good […]
Custom Painting and Airbrushing….What Kind of Masking Paper To Use
I created a video that demonstrated the steps to prepare a car surface for airbrush or custom paint. In the demonstration I used fine line tape, 1 1/2 tape and masking paper. I also mentioned another masking products, but did not elaborate on it. I was asked a question asking what that masking material was […]
Masking Jambs – Paper vs. Plastic
When it comes to masking there are more than one way to do it. On the Mustang project we used paper. However, if used correctly plastic can work well too. However, there are a few cautions to watch out for when using plastic against the paint edge, which we will talk about in this video. […]